Most likely some sediment has gotten into the lines. See if you can clean out the shower head aerator.
Make sure the valves at the water control panel are positioned correctly.
You might also have a on board water filter, and it could be clogged, or the valves going to it aren’t open all the way.
Lastly, there is a check valve at the water connector inlet on the outside. There is also a mesh screen washer at that inlet. Take out the screen and push in on the check valve to make sure it’s opening. The cone part of that screen should be facing outwards.
Was it winterized before you used it?
Disconnect the showerhead and the hose. It could be as simple as a clogged head or a bad valve in the head.
Water pressure from the tap is too high. Do you have a pressure regulator?
There is a valve that blows out inside the line on the intake side to keep from damaging the whole unit.
Take the intake water valve apart and you will see it. Reset and use a pressure regulator. Should be good to go.
Is it just the shower? Is the water just turned off on the shower head? A lot of rv shower heads can turn off the water at the head to save water while showering.
Screen blockage


