I am getting more acquainted with our new (to us) RV, and found some exposed areas in this black sealant above the windshield trim. Definitely looks like something that was added by the last owner, not manufacturer. Is it typical to seal around this soft rubber trim? And if so, what would you reapply?
eb86:
First clean off the old caulking. Peel back the lip of the gasket and clean inside with denatured alcohol. Wash the area and inside the gasket, be gentle. The run a tape line at the edge of the windshield gasket. Then use the windshield urethane and fill the inside of the gasket with just enough so when put pressure on the gasket a little pushes out. Allow the urethane 15min to set, then pull your tape.
Windshield urethane
Replace the gasket and have a auto glass company do it they will usually put a touch of urethane around the glass and gasket as well as a little around the outside this is more for wind noise than anything if it’s leaking you need a new gasket and by the looks of the bs the last guy did it will always leak now. Never use silicone or any product other then auto glass urethane.
Black silicone is rubberized and would work well and stay flexible
If you buy a tube of caulking make sure it’s non sag.
Flex Seal Paste. I’ve only seen it in black. Comes in a caulking tube.
Cleans up with acetone.
Have lots of rags.


