Super rusted or overtightened. Just used a long wrench and was able to super Hulk these off by hand. Any suggestions for drilling out?


Jeeps-R-Junk:

Reach underneath and keep turning the threaded part of the bolt with a vice grips it’ll
Come out

DBAYourInfo:

Penetrating oil, drill and tap, or weld a nut on the top

ihateapartments59:

Center punch it, and then drill it out. Insert new bolt. Be sure to get a case hardened bolt.

chris300zxtt:

You can pickup an extraction kit from the hardware store. Essentially, it’s similar to the drill/tap. You take a smaller drill bit and drill a pilot hole, then take an appropriate sized extractor bit out of the kit and drill it in. They are reversed so tightening the extraction bit loosens the bolt.

HamiltonSt25:

Go ahead and drill that bad boy out

Capable-Occasion-399:

Just drill through that sucker and grab the next size up bolts and some locking nuts.

yung_WHiTETRASH:

is it just a nut on the bottom side? if thats the case the only thing holding it on there still is a small piece of bolt. you should be able to hit that out with a hammer and punch, then just get a new nut and bolt at the local hardware store to replace it

Source: What do now? Snapped bolt heads off replacing tongue jack.

How to Winterize Your RV eBook

FREE eBook...
'How to Winterize Your RV'

Your Guide for RV Winter Living & Storage.

Valuable Tips & Info help you prepare for cold weather. Includes winterization instructions for full-time or part-time winter RV living.

It's FREE and there's no obligation...
Download your copy today.

Thank You! You will be redirected to the eBook download page shortly... After you've had a read through, please let us know what you think about the 'How to Winterize Your RV' eBook.