Are you sitting down?
It’s terminal.
4? Lol. Probably just need to replace the plug. Buy it from Amazon or your local rv store. You tube videos will show you how to replace. Chances are you had too much stuff running so check that out and look around for any loose connections.
5
just melt the other 2 to even it out and you’ll be fine
PSA: Buy a surge protector.
You going to need the RV side and a new cord or wire your own end. My recommendation. Purchase Marinco Park Power replacement parts and skip the junk. If that cord cam with your RV it’s cheap junk and not worth re-ending.
The Marinco cords come as a 90 degree which is nice if your inlet is outside and not in a storage bay as it relieves load.
Marinco Inlet and cord will run you around $450 from Amazon. You can cheap out, but if yours was originally good quality, you wouldn’t be in this situation now.
Edit: use dielectric grease on the new connector, inside on the wire at the wire terminals and in where the plugs connect.
Replace the plug and find out. I have had to replace those plugs before and didn’t have an issue later on. Turns out on my setup , it was the pole sticking out of the ground that was wired wrong.


