Pressure fill with city water. You can see the overflow has an aftermarket valve and cap. These systems have issues with the tank siphoning when traveling so people put a cap or valve on the overflow. Turned the water tank into a hydraulic jack. They are lucky it blew the tank out the bottom. I have seen this press the floor up and destroy cabinets inside. Large recovery rigs use the same principle to use airbags to upright tractor trailers. You can generate tremendous force.
This Happened to me I started filling the tank with the trailer in my driveway. I got talking to the neighbour while the water was on the water was going in faster than it come out the two overflows. The 2 bolts on the angle iron at both ends let go and the the tank fell. Took a half a day to get the water out and it back up in there.
It looks inflated. I’m assuming your shore water backflowed into the tank and the overflow didn’t work with the cap on.
what brand of rv is it?
It got pressurized. You can tell by the way it is. Clearly it’s bloated like a r/spicypillows battery
Had this happen to me. Nothing wrong but bad workmanship. 2022 Winnebago trailer. My tank looks like the one in the pic and is EXTREMELY flimsy and will not support any weight on its own. Not thick plastic like a waste tank. It’s supported by a sheet of particleboard between two pieces of angle iron. They cut the board a little short and when it filled up the first time the wood bowed and popped out of the angle iron supports. It and the tank pushed through the liner like in the pic. Drilled and bolted a metal strap between the angle iron supports so it couldn’t happen again. Good times.
The Boeing Effect


