My ac area was leaking. When I opened the grill to try to tighten the screws that hold the ac down to the roof I found the problem.

I think the ac hit something like a tree branch and was pushed back and the four bolts holding it down was bent as the picture shows.

I will need to replace these bolts.

Can I unbolt it from the bottom or do I need to climb on top remove the cover and un bolt a nut from above?


StrainHumble1852:

How did it get pushed back?

If it were mine I would push it back into place then try to get the bent bolts out. Then hope new bots will still tighten it down. I would also replace the seal because it is likely compromised.

cruisin5268d:

You definitely need to get on the roof to check for damage and inspect the gasket so you can get a good seal when the bolts are replaced

notsogreatbutok:

You’ll have to take the bolts out from inside. The nuts are threaded rivets not normal nuts and the 2 in the rear are not easily accessible.

ricklewis314:

Tree branch? More like overpass!

Source: Rv ac pushed back bent bolts

How to Winterize Your RV eBook

FREE eBook...
'How to Winterize Your RV'

Your Guide for RV Winter Living & Storage.

Valuable Tips & Info help you prepare for cold weather. Includes winterization instructions for full-time or part-time winter RV living.

It's FREE and there's no obligation...
Download your copy today.

Thank You! You will be redirected to the eBook download page shortly... After you've had a read through, please let us know what you think about the 'How to Winterize Your RV' eBook.