How the heck do I get this back in the track?
I can’t tell from one picture but either:
—The roller hardware is fastened to the top of the door and the bottom of the door is swung out on an an angle to engage the rollers. Usually on hollow lightweight doors.
Or
—The rollers are put on the track before the track is installed, and then another part is installed on the top of the doors. Then then doors get hung on the roller hardware with a little locking lever. Usually on solid heavier weight doors.
Better pictures will yield more accurate answers.
Good luck—
Unscrew the track and slide it in from one end.
Add a drop of Loctite! Both my sliding doors came off the track. The first one came off twice, neither came off after adding Loctite. Why the factory couldn’t do that is just dumb.
Mine did the same and I put the roller assembly back in the track, but had to bend the track back into place. I finally just removed the door.
They actually will go in at an angle. You have to angle the door outward until the roller bottoms fit in the track then straighten the door which angles the top of the rollers into place
Source: Pocket door fix


