Hi all, fairly new to trailer camping. We recently had a new axle, spindle and bearing professionally installed on our camper trailer after an old bearing failed (used trailer, wheel and half the drum came off while travelling). First trip out since the repair and a new dust cap came off on route. I'm trying to figure out if this is a concern. Easy enough to replace a dust cap but would this indicate some issue with the bearing install? Bonus question, I had requesting new bearings for all 4 wheels. The tech did the back 2 with the new axle but only repacked the fronts (said they were good condition) but charged same a quoted for all 4 new bearings. They're kinda beating around the bush about it but I'm starting to feel like a paid full price for a job that wasnt completed and the part they did maybe wasn't done well. Am I over thinking it? Let it go?
If you paid for 4 bearings to be replaced they should have done all 4. You are right, you can can just replace the dust cap. However I would avoid what one person wrote and “just squeeze a bunch of grease into it”. That is how you blow out the seal and get grease all over your brakes shoes. If you aren’t positive how to fix this, call etrailer.com. They have a lot of helpful videos and parts.
The rubber caps that go in the hole are shitty now days from my experience. Many products are shit
It happens. No big deal. Just replace the cap.
You can buy a dozen of them for ten bucks on Amazon.
It could be just a dinted up old dust cap that didn’t hold on. I’ve also encountered, on my own trailer, “professionals” screw up the bearing install and the result popped the dust cap off. It happened on two wheels. One was simply the cotter pin through the castle nut wasn’t bent over correctly. The other was because the bearings weren’t seated correctly.
Anything is possible.
I would probably just squirt a bunch of grease in it to clean out any dirt that got in and replace the dust cap. I wouldn’t worry about the bearing.
Source: New bearings dustcap fell off


