Etrailer has a ton of coupler repair kits. Yours looks like a Demco, but i can’t be positive on my phone. Somewhere on the hitch it will have a brand name and weight class. You may need a wire brush to clean it up to read.
Go to tractor supply type store, they have new complete couplers comment and a lot of times you can just disassemble a coupler and put the parts into yours. I’ve done this before
Not that this is terribly helpful but knowing the coupler brand should help find parts. Look to see if it’s engraved on the coupler.
It wouldn’t hurt to make a few calls to trailer suppliers and/or welders and see what it would cost to replace. Maybe it’ll surprise you, maybe not but you’ll have plan-b sorted out if you need it.
Your coupler is obsolete and isn’t made anymore. This is the part kit you need, if you can find an NOS one: https://centrevilletrailer.com/product/atwood-2-516-coupler-repair-kit-obsoletediscontinued/ Other than that, you’re better off having a good weld shop cut off and weld on a modern coupler.
So I have an older(84) holiday rambler with a 2 and 5/16th ball. When I got to my destination, my ball would not unhook, after I finally got it off I discovered that the lock(posi-lock?) broke off and I’m stuck here until I get a new one. I have looked high and low on the internet, amazon, e-trailer, ebay, you name it and I cannot find a lock that has a rectangular shaft like the one in the photo under the spring. I also contacted the biggest RV dealer in Texas and they told me I was SOL. My only other option is to buy a whole new hitch and have the old one ground off, and welded on by a mobile welder. Does anybody know where I might be able to find the proper replacement lock?
Source: My ball lock broke off while on vacation? Help me find a part.


