Looks like JIC to me, unsure if that type of hydraulic fitting is used on a winnebago, if it is, 2 should spin independently of 3, but 3 should be integral to the hose. I haven’t ever seen a brass JIC fitting before though, although I work with what I would assume is higher pressure hydraulics than what a camper/trailer has. If it is leaking between 3 and the hose, you’ll need a new hose, if it’s leaking between 2 and 3, you will likely see oil on the other side of the hose nut.
Source: Industrial Mechanic
That’s an interesting looking hose… what are we looking at here? What flows through the hose, vehicle, OEM? Hose fitting type? Thread sealant?
3 has some seals that are sleeping on the job.
Just get a new hose made at any hydraulic hose manufacturer or even a truck supply. Easy fix.
Many different things could have happened here.
-
someone could have over tightened the connection between 2 and 3 and cracked the seat on the female
-
there could be a hairline crack beneath the seat on the swivel nut (3) from vibration/ movement.
-
the sealing face of either the male or female could be compromised
-
it could be slightly loose, have you tried tightening? If it’s a jic just don’t just crank them down or you’ll crack the seat (see 1). Hand tight then a quarter turn with a wrench is all that’s needed.
-
if is leaking at the house coupling interface, I would suggest the hose be replaced. You could have a hose shop just cut the end of and crimp a new one on but you’ll lose a couple inches in length. Not to mention if your rig is a 06, that hose is 17 years old. Hoses are a consumable/ have a finite lifespan and need to be replaced eventually. You may do all the work to have a end repaired the only a couple months down the line to have the hose burst from old age.
As stated you will need a new hydraulic hose or possibly someone with the right fittings and proper crimping tool could put a new fitting on . This hydraulic hose will be for either a slideout or a jack .


