No_Map3693:

You just need to adjust how the latch drops into the strike plate. Needs to drop in just slightly earlier. There’s adjustments on that lock that I didn’t see either when installing and had same problem. Can definitely be adjusted and solved with the same screwdriver you installed it with.

Edit: could be other stuff too I guess but most likely that if rig is brand new and just started when you installed the lock

Paris_d:

I’m convinced there’s not a single RV off the lot that has properly aligned strike plates.

​

Unscrew the plate, pray your screw holes aren’t stripped, and reposition. Back in latch-action.

whazza_what:

You can often adjust the plate that the latch clicks into pretty easy. Just move it out a little.
Or check to make sure the latch is centred on the strike plate. you might have to move it up or down.

GilreanEstel:

  1. Are you level? My doors act hella stupid if not level. A little torque in the rig could offset your strike plates.
  2. Do you have the drop down stairs? Are they as low as they need to be? There should be feet to adjust on the bottom. Spent a very frustrating week the first time out because the door kept sticking and not shutting. finally realized that the issue wasn’t actually the door but the stairs.

RasterAlien:

We had this problem. Just a little lubrication completely fixed it.

maltedbacon:

Sounds like you’ve got it mostly remedied.

I had a similar problem on a used trailer with a slightly misaligned door. There was no adjustment I could make which solved the problem, so I just used a grinder to modestly enlarge the hole in the strike plate. Worked a treat.

stephensatt:

Yeh, fought that allot with my new NOBO trailer. Here is what I did. First adjust the striker plate. I had to remove mine, take a dremel and carve out a bigger hole, put it back and then I had to JB weld in the screws because they were stripped from the factory, as the door frame is very thin aluminum.

I did NOT have to adjust the lock and that might be difficult as mine fits the hole precisely.

The next thing I did, was on the inside of the lock is 4 screws that go through the door. I took the one thats the upper left , removed the screw and put a nylon strap in a loop, put that screw through it with a black washer and screwed it back into the door. I now have about a 6 inch long black strap hanging on the inside of the door and we pull that instead.

Way more solid with the strap, then using the cheap plastic handle that feels like it would break.

Let me see if I can link to a pic of something like it.

Here ya go. It looks just like this now, but black strap hanging out under the screw. Very solid and lets you pull the door closed tight without even touching the handle.

https://www.tyrolsport.com/interior/safety/rennline-rs-door-handles/

​

Oh, I also periodically use clear “bulb grease”, like a clear silicone based grease and I put that on the striker plate and the bolt , works well. Clear if it comes off on your skin and hands and clothes , ya don’t see it.

Source: Latch not grabbing – slam the door, or hold open the latch and push hard is the only way it works. Inside I have to slam it multiple times to get it to close.

How to Winterize Your RV eBook

FREE eBook...
'How to Winterize Your RV'

Your Guide for RV Winter Living & Storage.

Valuable Tips & Info help you prepare for cold weather. Includes winterization instructions for full-time or part-time winter RV living.

It's FREE and there's no obligation...
Download your copy today.

Thank You! You will be redirected to the eBook download page shortly... After you've had a read through, please let us know what you think about the 'How to Winterize Your RV' eBook.