Pull the slides in. ????????????
I was given exactly one instruction after my first purchase.
“Look Up”
So, make sure you have situational awareness above you.
You should be fine with sway bars if your not using sway bars then bring a couple pairs of underwear.
go slow, a half ton pulling a big bumper pull is about the most dangerous set up out there (non-commercial). Don’t get overly confident because you see other trucks / trailers bigger than yours flying by. I’m an otr truck driver… I see more of these things flipped on the side of the road than anything else being towed.
Empty your tanks obviously, keep the trailer properly balanced. I probably wouldnt go above 55 tbh. Don’t overload your truck bed, you’ll need all available payload for the trailer. Avoid windy areas >20mph. Stay in your lane / don’t change lanes as often as you might in a car.
Don’t pull into weigh stations, unless signs explicitly tell you to. Use truckstops with dedicated RV pumps if you can. If you need to park with semis at a rest area or truckstop, park in such a way that you’re not taking up great spot that might be the only spot an oversized load can fit in. Your trailer feels big, but realistically its much smaller than a lot of rigs the world is designed for. You’ll be fine, just take it slow and stay away from everything and everyone, whenever possible.
Edit: for those that don’t know, flashing your headlights to a truck trying to merge into your lane means “go ahead”. Once merged, the truck may flash their rear tail or clearance lights back as a “thank you”. This seems a little silly, but if you’re in any sort of weather or poor visibility it becomes important and is appreciated by truckers. It’s just nice to know communication is happening and people in the big stuff are paying attention to each other. Find your “go ahead” and “thank you” buttons ahead of time ????✌️
As an experienced full-time RVer and retired truck driver, for heaven’s sake make a check list, or a “Goby” as I like to call it. I still use my list for all intents and purposes. Getting older, I tend to forget little things like locking the slides for travel, or returning the pins for the awnings. Stupid mistakes are just that, stupid. Make a list, and check it twice until *always checking that list becomes 2nd nature.
*edited for clarity, emphasis on checking the list
Yes, stop off at Harbor Freight and get a good 4 way. Make sure it fits your lug nuts before you leave Harbor Freight because it might not, I had to “dremal mine out” to fit. Also stop by a metal recycling place and ask for a 4ft long by 3 in, “thick walled” pipe to use as as cheater bar. This is to slip over the end of the 4way for leverage. I have had about 4 blowouts in the past 20 years of RVing and road side tire changes can be a real hassle because the lug nuts are so tight. No one thinks about that pipe until its needed and you are stuck with a flat. I also carry a small compressor and tire plugs too. Also the fancy tire guage that Harbor Freight sales, it has a black colored meter on it, its all metal and brass , including the slide meter, so its WAY BETTER than all the cheap plastic ones. Those are hard to find. I had a brass one from 20 years ago and it finally broke and couldn’t find them anywhere. HF has it now.
Get in a good argument with your family members when you back into your next spot. It is something that will happen so expect it. Everyone loves witnessing it. Good luck
Source: It will be my first time towing our home tomorrow, any tips?


