My 2022 Foresters electric slide is hanging up. I have 4 aluminum tracks, 2 on each side.
Can anyone advise on how to fix/trouble shoot this?
It's supposed to go out to a camper in about 12 hours, and I don't want to ruin their weekend.
This is the first time iv ever had the slide do this.
Google “how to sync a swintech lippert slide”. I’ve had the same problem. Many solutions on the web
Are you on shore power? I heard moving slides on batt messes it up sometimes
Not 100% sure what the problem is, but first troubleshooting step depending on the type of slide. This may work for you or may not:
Find the slide controller box. It’s a black box with a white label on the front of it. About 4″ x 5″ and 3/4″ high. Might be underneath in the storage bay, might be up on top of the slide or in a nearby cabinet. In the bottom right hand corner of the white label is a small cutout with 2 led lights in it – red and green (maybe 1 light that switches color – depends). There’s also a small button in there you can push. Push it six times then hold it down the seventh time until the red and green lights flash rapidly. Then go back and try the slideout again and see if it works.
What brand slide motors? It could be a simple re program of the motors so they are aligned back up and go in and out at the same time. It happens to our slide when we stay stationary for a while and then we re program and have zero issues for many months on the road again. If you un screw that motherboard you’re using to click the slide in and out you’ll see a few lights flashing, google the brand slide you have and add re program slide. It will tell you what buttons to push behind that front plate to re program it.
I hope I explained that well enough. If not feel free to message.
Just in case… have you checked behind the other slide end to make sure something didn’t fall back there or get caught?
https://youtu.be/lqsWi27CLiU?si=rAX4e3I9UPIVZvOX
Try this. If it doesn’t work, there is a way to disable the motor on the opposite slide that allows you to get it in or out in a pinch. Not very difficult. I’ll try and find a video
You can wiggle it forward/back repeatedly and resync it sometimes. In a few inches, out a few inches, repeat until it’s moving evenly. If that doesn’t work, you can put the Lippert slide controller into “manual” mode, which is a complete misnomer (there is no manual mode); it just overrides the sensors so you can use the controls to engage both motors at once (see u/coletd94134’s link).
I hear a pretty loud click when you move it in both directions. That could be something catching (trim/cabinet, something stuck in the gears/rails, even the motor cable getting caught up in the mechanism). It could also be the gears slipping on one of the rails. When it gets stuck like that and you keep trying to move it, this is more likely.
That happened to mine, because the cheap plastic rail guides broke and the rail separated from the gear too much. Before I realized what was going on, the gears had shredded the aluminum rails pretty badly. I only hear two clicks on yours, so I don’t think you’ve got the kind of extreme problem I had, but beware; if this is what’s going on, you can damage the rail badly enough to require replacement. If it skips even one or two teeth on the rails, the slide will be misaligned and compound the problem, and it can get stuck entirely. There’s no easy way to diagnose this specific problem, other than listening for the gear skipping and looking for damage on the rails. To see if the plastic rail guides are broken, you’d have to take the whole Schwintek mechanism out of the wall.
Source: I have this going out in about 12 hours to a camper, help me figure out how to troubleshoot shoot!


