We have these motion sense lights which I like, but one was installed upside down by the manufacturer and it blasts those sleeping the dinette at night. Wondering how to take cover off to flip it over?
I am about to rip one of these off of the kitchen area in my fifth wheel. I’ll take some pictures, and report back.
The picture doesn’t provide enough info to say 100%. But I imagine the cover is just held on with clips and behind the cover is a screw or two. Something flat and thin like a putty knife between the wall and the lip and a little pressure it should pop off. Again this an assumption based on the photo and not my fault if I’m wrong and you break it
Pop the front panel off with a small flat head or blade, then there should be screws behind it.
I removed it. Pried it about a centimeter away from the wall. Then put thumb on motion sensor bulb pushing in while pulling out of plastic housing. It popped off from there and I was able to rotate it.
Source: How to Remove?


