Newbie camper owner here so please be kind lol????. How do we level our camper in our steep driveway without using stabilizers? We have been cranking the jack up, putting stabilizers down, lift up jack, add another block, repeat until we added all blocks. When we unhook the trailer from the truck we’re only able to add about 2 pieces of plank under the jack initially so we have to use the stabilizers to hold the camper for the few seconds it takes us to slide more planks under. There has to be a safer way to do this.
Suggestions?
Also I know we need more blocks under stabilizer – we have some more ordered.
Stabilizers at that height aren’t the best either. I think you have the right idea about using blocks but I’d make some form of platform and/or feet that you can store and move into position when you need them.
I had a similar challenge so I built these blocks out of 4x4s glued and screwed, with the 2x6s wrapped around for extra stability.
I can slide it under the tongue jack and it reduces how far it has to crank.
Stabilizers are not for leveling – at all. Full stop.
They are to stabilize/stop the bounce…. Not (ever) for lifting/leveling.
This isn’t a if it falls it’s a when
I use the same method as you. The main thing is the stabilizers are not designed for lifting up the unit, but they can hold the static weight fine. I wouldn’t leave it on just the stablilizers and jump around in the unit, but for the 1-2 minutes it takes to raise the tongue jack, insert new blocks and lower it down again, its not a problem.
The two things I keep in mind when doing mine:
- Make sure you have really good chocks, that way if a jack were to fail or a block were to slip out, it would just pivot onto the tongue jack/next point of contact.
- Keep everyone away from (and definitely not under the trailer or tongue) while in that state. Again, if something was to fail or slip, no one could get hurt.
To start, to much strain on jack, that high, at that angle.MORE BLOCKS , ARE A MUST, if driveway is that bad. Stabilizers, YEAH , WAY TO FUCKING HIGH AS WELL..But that pressure on your Jack, is insane.
You need to be pretty careful doing this process, those stabilizer jacks aren’t meant to handle that kind of load. I’m a tech and I’ve seen more of those jacks folded in half than I can count because people think “jack” = “lift heavy loads”. These do not do that and most definitely will fail. Also the extension of those jacks to the point you have shown makes them significantly weaker. If anyone was inside and shifting around as those things were holding all the weight, they’d bend almost certainly. Please don’t get hurt.
Source: How to level in steep driveway without using stabilizers?


