I took the bars off of my weight distribution hitch before I parked my trailer and it slid the hitch down or back from where it was (top nut). You can see the rust mark where it was. Should this be loosened and set back or will it come back when I hook up and put tension on again? I’m not sure that there is a place near me that could help. I would appreciate any advice.
It’ll likely settle back into position once the bars have tension, but no, it’s not supposed to move. There should be a bolt near the bottom that acts as a stop. It’s either gone or is working it’s way out.
Yes, you should fix this. You should look up and follow the torque requirement when you reset those bolts.
I’d also suggest replacing that top washer with Galvanized so it stops rusting your hitch.
In addition to getting the proper washer (Probably a conical lock washer that flattens under torque), and greasing your ball, I would replace those bolts with new ones.
As a matter of fact, I would buy new bolts and washers from the manufacturer so you know you got the right spec. You can usually borrow a Torque wrench from your local auto parts store with a deposit.
The angle of the hitch has two parts. First there is a set of washers on the top that set the angle. Those should be sandwiched tight in the hitch. Second, there should be a bolt at the bottom that you tighten to ensure the hitch cannot move. My guess is that 2nd one is loose.
Having this slop is a problem because the hitch will slide while driving changing your leveling bars will change pressure. That angle drives how much weight is distributed. You may also hear major clunking when that hitch slams back and forth.
So loosen the side bolts, tighten the bottom until the hitch is secure, then re-tighten the sides.
That looks like my elite set up. You have a good marker in which to put the hitch back the way it was. It looks like a lock washer could be in order.
Looks like you fuxked the hitch those bolts are supposed to be opposed and torqued to 250 ft lbs.
Obviously it slipped because of the shit washer you used instead of a locking washer the other ones got.
Obviously slipping bolts with that kind of tension is gonna damage something and that hitch will likely never stay tight again
Do not pass go, do not collect any dollars and replace that hitch or have it looked by a pro before using it again or it’s HIGHLY LIKELY TO FAll APART.
Source: Hitch Setting Moved?


