Also has anyone done anything like this before it’s kind of a first thing for me and any advice would be helpful
Usually nothing structural about the bed storage area apart from supporting the lift of the bed itself. Every RV differs but none of our trailers would have suffered from a cat door there.
Don’t buy from camping world.
That piece of wood is the thinnest, cheapest material the RV manufacturer can find. The support pieces are just a frame of 2x2s with those panels slapped over it. Lift the bed up and check but there should be no reason not to cut a cat door into it. I’d recommend buying a cat door opening that you’d put in a house door or wall, otherwise you’ll have unsightly rough wood edges.
Depends what’s under there. Have you looked? Mine is a ton of slide mechanisms and a bunch of plumbing. I wouldn’t want my cat all up in that.
Probably not, but hard to tell from this view. If you post a photo of the back side of that font panel from under the bed, it will show the framing. Worst case you would have to add a little extra framing to reinforce it, but that is unlikely. I need to look at the same thing on our camper, because I’m considering putting a big pull out drawer on heavy duty drawer slides under the bed on ours.
On mine there is plenty of room for a cat door. It is a raised bed with 2x2s wrapped in oak paneling. Just try to space it in between supports.
Don’t cats find a comfy space on their own? What if the cat doesn’t like the ‘den’? Then you’ll have a hole in the base for nothing..
When we converted to lithium the battery we chose is 22″ long. To accommodate its size I built a compartment that goes partially under the bed, with the rest in the passageway next to it. So, in essence, I cut a big cat door.
As others have pointed out, you’ll likely be working with 2x2s and paneling.
I had to cut one supportive 2×2, so I reinforced it with some extra supports around it.
Then used a jigsaw to cut the opening in the paneling.
Fairly simple job for anyone with rudimentary woodworking skills.
We’ve, uh, stress-tested the bed since and can detect no weakening of its structural integrity.


