2020 Salem Hemisphere 26BHHL – Has anyone had the bottom flange of the I-beam tear out? The welds of hangers to flange are intact and seem ok. I can’t find any signs of stress in the web or the top flange. But judging from the rust on the exposed areas this has been separated for a while before it finally tore. Looking at the other hangers I can see rust/cracks forming. Would tractor trailer repair facility be the best option? Or would you try and make an insurance claim and let them figure it out?
Any welder should be able to fix that pretty quick and cheap for you. A dealership is going to try and make it way bigger of a problem than it actually is. Definitely don’t claim insurance on it, it would probably only be a few hundred bucks at most to fix.
As the others have said, any welder worth their salt should be able to fix that quick and easy.
A small piece of 2 inch by 3/8 flat bar, maybe a couple of small gussets… any decent Mig welder should fix that stronger than new in short order.
That’s very common, unfortunately. Lippert has a recommended procedure to fix that on their website. Involves welding a long tube between those mounts so they can’t flex. Just search “lippert frame repair pdf” one of the first results I’m sure. Just welding the broken piece results in a worse break soon
OP,
I saw your post on FB. Ouch. If it were me, I’d just have a buddy weld it. Not sure what your risk level is. You can go the full refund route like they’re saying on FB but it will be an uphill battle.
I guess it depends on how much energy you’re willing to put into this.
Had this exact problem happen to me a year ago, that attachment was failing on my TT.
I took it to a place called State trailer and RV supply and the guy there got it welded up in a few weeks, cost me about 800 dollars.
I also got in contact with the frame manufacturer, Lippert, who apparently makes a lot of these frames for a lot of these trailer companies and this seems to be a common problem. After a couple emails back and forth they agreed to reimburse me the cost of repairs.
Not a frame failure, and a very easy fix for a welder. Happens all the time
Source: Frame failure


