A forklift at a storage yard ran into the front of my 2021 Wildwood 273 QBXL. I was fairly compensated for the damage, no issue there. The damage is approximately 5″ wide by 3″ tall.
Instead of replacing the whole panel, does anybody have any creative ideas on what I could do with this spot? Anything functional to put in this place, or something creative to cover it with? Currently have a couple layers of gorilla tape over it while I figure things out.
Big reflector, put one in the same spot on the other side as well. It will look like it came that way.
Not really creative, but what I would do instead of replacing the whole thing:
You could cut a patch from similar material (diamond plate aluminum sheet), then drill holes through it and the the nose skin, then install it with pull rivets. Use a layer of sealant between the patch and the skin, both to seal the patch on and as an adhesive while working it. Once you’re done, paint it black to match, and run a bead of sealant around the edge to cover the sharp edges.
FYI for those without this on the front of their RV and who haven’t seen it up close, it’s not real diamond plate. It’s very thin, like foil tape or those tin ceiling tiles. I had a branch kick up and hit my last RV the day after I brought it home and punched a hole the size of a silver dollar all the way through this stuff and the wall. Couldn’t find anything that would match and there’s no way to use real diamond plate to “patch” it since it’s so thin and going into a thin wall.
Honestly, I just stuck a really wide piece of gorilla tape over it and left it like that. I think I swapped the tape out once in the time I owned it. Sold it with the tape in place and not a word was said about it. Yours hole is a little larger than mine, so perhaps a square of roof material with some sealant on it.
Flextape, duh
I have fixed several issues like this. Just replace the rock guard, if not you will end up with water damage
Go to hemetvalleyrv dot net and call the number. A full width replacement for that panel should be under $200.
Checker plate wide enough to cover the damage and height of existing checker plate. Do the same the other side to make it look symmetrical and deliberate.
Source: Does anybody have creative ideas on how to “fix” or cover this hole?


