I just setup a diesel heater, I got this CO meter to be safe. It always reads 0 ppm. Is that normal? I was under the impression I should see 5-15 ppm in a regular closed environment. My dogs and I are breathing in an enclosed 6×12 cargo trailer camper conversion. There is some ventilation, but I still never expected to see 0 ppm.
Even if I breathe directly on it, I’ve never seen it say anything other than 0. The instructions were pretty basic, I think I’m using it correctly.
Should I return it? Does anyone have experience with CO meters?
My heater has been running for a little over 2 weeks and I’ve never had a headache or anything.
Stick it near a running tailpipe. If it’s still 0 it’s broken.
Breathing doesn’t generate CO, it generates CO2. CO comes from incomplete combustion
Buy a couple CO detectors and mount them in the camper. Redundancy is good
You can get CO detectors, like smoke detectors, that run off a 9v batt at home depot for like $16. Get 2 just to be safe. Fuck it man it’s just money and you don’t want to die in your sleep right?
If your diesel heater was installed correctly, there should be zero fumes inside. It’s a closed system, that pulls combustion air in and exhaust air out in one loop. A separate heat exchanger heats the inside air.
The two should never mix, unless the heat exchanger cracks, or you didn’t seal up the exhaust pipe where it exits the trailer.
Make sure you fresh air calibrate… if you fresh air calibrate inside your space it will read zero.
Do a running car tailpipe check to verify it works 😉 50ppm is the 8 hr permissible exposure limit, I wouldn’t accept anything close to that inside your space????
I just bought this same meter and have had it run up to 83 ppm in my house randomly, but most the time 0 ppm. Haven’t done the tailpipe test yet but plan to. I bought another more expensive meter and it just says 0 ppm everywhere I test in house. I have a fuel oil furnace so just trying to make sure.
Source: Can I trust this 0 ppm reading?


