RV Pro here.
Take the element out (1 1/16″ socket) and put it back in.
What happened here is the installer put that one in way too tight. There is a little rubber seal on the back and if you squeeze it too hard it pops out of alignment.
So, remove the element and check the seal. Then reinstall. I am sure it will be fine afterward.
If is still leaks a new element can be found at lowes in the hot water heater section for less than 15.
Looks like the element needs to be tightened. You should always check those when installing as they are often only finger tight. They sell the wrenches for under $5 at HD, Lowes.
The outside power switch is still off, so had you energized it inside via electric nothing would happen. Had it been turned on and soaked it would have tripped the breaker long before a fire started. And had a fire started it’s like a built in sprinkler system.
Until you checked for leaks, you wouldn’t have energized the system – would you ?
Don’t leave anything like that on while you’re gone.
The point it’s leaking out of is also where you’d connect the wiring for the electrical element. We hadn’t done that yet, and it’s a good thing. Imagine we’d hooked everything up and then gone to town or something….. That definitely could have sparked and caught fire. Our entire rig could have gone up in flames, along with all of our belongings and our two dogs. I’m so angry. As it is, I’ve got a soaked subfloor and no water. The distributor and I are going to be having a nice, long talk.
Source: Brand New Suberban Propane/Electric Water Heater- The Interior of My Rig is Sopping Wet Now


