Maybe I’m blind but I don’t see any delamination?
Heat and humidity will cause this to occur, I would say if it was water it could have got in during use or transport and storing it caused humidity inside the camper. I would say, if you haven’t already, replace the delaminated areas. Check for mold, and put a new roof on. Check your exterior seams and undercarriage.
Those clearance lights are a major source of water intrusion, but you always see localized delam underneath the lights first. If you let that continue, the whole panel can let go. If that wasn’t the sequence of events then I’d say the glue failed due to poor bonding from the factory.
Apparently the entire ass end panel on our camper has decided to delaminate. I can’t find any sign of water infiltration. The roof is in good shape with no issues and all seams, seals, and caulk are intact and look good. Annual warranty inspection was done in the fall and nothing was noted. They did some reseal but that was on one of the slides. It was stored inside from mid-october until mid-april and there’s a zero % chance it got wet. This isn’t localized. It is literally the entire panel. What do I do if anything? Pics are from when we picked it up (new) but I posted them to show layout and construction.
it’s just the nature of the beast. delam always happens sooner or later. rv body shops are about $200/hr.
Most of the time it’s water intrusion, but I’ve seen defective bonding where the glue just lets go over time.
But yeah water is typically the cause.
Not sure where it was originally used but if it sat in the Arizona sun for 7 years, it will cause delamination. No water needed.
Source: Is water the only cause for delamination? 2017 Keystone Laredo 325 RL


