DO NOT TAPE OR DOPE FLARE FITTINGS!
There’s a lot of bad advice in this thread. A flare fitting should be bare metal to bare metal, free of debris. Anything else leads to leaks.
Try removing the hose, inspect the fittings, then reattach the hose and tighten. If it still leaks, replace the hose.
Tightening them first would not hurt.
Was the service appointment for propane lines?
Based on the bubbles, I’d bet it’s the swivel joint before the male threads and the hose needs to be replaced. These look like regular 1/4″ NPT rather than inverted flare but unscrew them first to know for sure.
Just get new lines. Prolly round $40
Was this perchance done by a “tech” at camping world?
I had a leak at that part of the connection and ended up just getting a new hose which I found at ACE, it was a standard pigtail hose. It happened after I replaced the propane cylinder, must have put too much pressure on it or something because that’s not the part I unscrewed.


