New (to me) camper. Came with some issues including my water hook up. My city fill is filling my tank. I know traditionally that means bad check valve on the pump but thought I would see if it can be something else first — this camper has the hookup and the valve(?) selection rather than the traditional city hookup vs tank opening that you put your hose in.
Can there be a failure where the water comes in? What does it look behind this panel? Of note, I couldn’t get the city fill to work but was just assuming that’s because it’s not building pressure (because it’s going into the tank)?
Appreciate any guidance.
Also, do I really need to feed mix my diluted bleach down the hose, hook up the hose, and use that to treat my tanks? Seems crazy to me that they didn’t come up with a better option where I could just pour it in. What was wrong with the old simple system?
First guess is a problem in the water pump. There’s a check valve that might be stuck.
One easy thing to check. Does your trailer have a shower miser? If so shut it off. It will divert water from your city water into your freshwater holding tank. If you don’t have a shower miser you probably have a stuck check valve.
Did this start immediately, it only at the end of filling?
I’d look to the water pump, check valve may be bad. Quite a common issue
First, are you sure you’re connected in the right place? There’s another hose connection to the left, that looks like a traditional water input.
It’s hard to tell from the video, but it appears that you have an adapter of some sort on the hose.
A good pic of the entire water area might help.
If that is the city connection, there are a couple of possibilities:
-
Somewhere along the way, the position of the valve changed, and it’s not labeled correctly anymore. Our entire valve panel was replaced with a newer one, and the sticker no longer actually matches what it does (some dealer also switched the grey and black handle positions at one point, so the stickers are incorrect for the dump valves as well).
-
The valve has failed, and is letting water flow through to the fresh tank while in the city water position.
-
The valve isn’t fully locked into the city water position, and is allowing water to flow into the fresh tank.
I would definitely try to flip the valve, and see how it feels, and if it changes what happens in the other position.
Is the drain petcock on the water tank closed ?
As others have said, your water pump has likely failed. It acts as a check valve to prevent city water from flowing back through the pi
O and I to the tank over time they fail which of course allows water through the pump and slowly fills the fresh tank. You can either replace the pump or just cap the line if you do t use it.


