What’s the next step?

Floor?
Paneling the now insulated walls/ceiling?
Electrical?

It’s taken a lot of work to get to this point of needing a lot of work-


saraphilipp:

Get busy living, or get busy dying.

HowsBoutNow:

I can’t help you, but this is inspiring to me. Good luck

BedBugger6-9:

I would run electrical then ceiling

homesick_for_nowhere:

Its iterative. Basic electrical and plumbing layout, running wires and pipes, anything you want under the finish. Then walls, ceiling, cabinets. Then finish the elec and plumb fixtures.

slayedzombie69:

Hot tub

AirForce_Trip_1:

Fill the entire thing with filler foam, then cut out a bed area.

krbjmpr:

If this was one of my builds, I would have already run the electrical for 120vac (BX wire) and 12v (in conduit) to locations that I would be using them in, THEN put in the insulation. Same goes for squaring up any corners / appurtenances. Pull insulation away from door, and reinforce opening. Same for windows and other vents.

Waterlines would have been switched from PB to PEX already, and likely run inside 1.25 or 1.5″ PVC (that drains to outside) for leak management. Heat pads / cable under plumbing sections and tanks.

Buy insulation set for water heater (in cardboard box in lower right corner?). It will save you a bunch of propane and keep water hotter for longer. Consider adding a small tankless water heater with its own dedicated power feed out to the pedestal. Add tankless AFTER the LP water heater. Run a 4cond trailer wiring cable between water heater location and convenience panel for future upgrade to water heater for LP/Electric operation. Install water heater (tank type) that can heat with engine coolant. Bonus points: run 2 PEX pipes up to ceiling / roof area for future solar water heater (mine was just a coil of pex pipe on top of coach).

Upgrade electrical service from 30A to 50A.

Convert furnace to CheapHeat solution. This normally requires some work to be done to ductwork, now is prime time to accomplish that.

Insulate wheel wells (spray foam works decent) for temperature AND road noise.

Replace water tank fill and vent hoses. Why? Easy access, save headache down the line. For fill, I like to use Flexible PVC pipe, but that may not be appropriate as it does not like curves very much.

When wiring outlets and switches, use box extenders, similar to Leviton 6197-xxx, so that you can use regular electrical receptacles and switches and not the silly squeeze and pray devices.

Just off the top of my head…

Source: What’s the next step?

How to Winterize Your RV eBook

FREE eBook...
'How to Winterize Your RV'

Your Guide for RV Winter Living & Storage.

Valuable Tips & Info help you prepare for cold weather. Includes winterization instructions for full-time or part-time winter RV living.

It's FREE and there's no obligation...
Download your copy today.

Thank You! You will be redirected to the eBook download page shortly... After you've had a read through, please let us know what you think about the 'How to Winterize Your RV' eBook.