I need to replace the old base wood to extend out to the walls. We get heavy mildew in the under bed storage, you can see the dark spot in the wood. What type of 3/4” plywood can I use that is water resistant.
Most cost effective would be a decent sanded plywood and then seal it completely (including the edges) with a good primer/sealer.
More important is finding and fixing the source of the moisture before it causes more damage.
You can buy Marine plywood, it is designed for wet or humid environments
Just get some sanded plywood. Then get some 1×2 trim boards and run them down the plywood and make airways for airflow. Then get a tower fan on a timer.
Is there an unheated storage bay below the bed? If so, insulate the top part immediately under the bed. That resolved the mildew issues we had.
You probably don’t have ventilation and a tiny bit of negative pressure that you need prevent mold/moisture. If you are seeing that under your bed, it’s probably also around the storage comparments and walls where you can’t see it.
RVs aren’t ventilated like houses so you have to crack the vent/window or run a fan. You are going to waste a little heat to get the bad stuff out.
https://www.hvi.org/hviorg/assets/file/public/publications/moldpaper_final1june09.pdf
In very extreme cases the use of a product under the bed like ‘Hypervent’ is required. Normally RVs just need more ventilation.
Not directly what you asked but 3 other things you could do and never have this problem again:
-
Get a portable dehumidifier and keep your indoor humidity at or below 50% at all times. I have a 22 pint model in a 40’ fifth wheel and have to empty it about once a day on average. I’ve never had condensation on my walls or windows ever.
-
Put a waterproof mattress protector on your mattress to keep it from absorbing sweat. Just the kind that covers the top and sides is sufficient. You don’t need the whole zip up bedbug type.
-
Buy an airflow matt to go under your mattress. It leaves a small air gap for evaporation.
Air flow is key.
The heat from your body is transferred into the mattress, and under that mattress is cold storage thus causing the moister. It’s very typical for trailers.
I built a small frame under my mattress using 2×2’s for some air flow. Problem fixed.
Some people suggest changing out the wood, or painting it, but IMO that just makes the moister stay in the mattress, and it will start to mildew and stink to hell.
Source: Help with bed conversion


