New to this. Parked the trailer and the coupler won’t release from ball. I knew I should have probable greased it but here we are. I’m thinking the latch is actually what is stuck? I think I usually see these extend all the way out, while mine can lift up a little.
There is no incline to drive up on and tried rocking the truck in neutral to give it a slight budge no luck. Also tried giving some weight on the back of the pickup.
Thinking it’s the latch now?? Any advice welcome!!
It is not going anywhere until you lift the lever on the top of the hitch up.
Here is an idea. Get as much weight on the jack under the hitch as you can without lifting up the back of the truck more than 1/4″ or so. Chock the weeks on the trailer. Pull the pin out of the receiver and pull the truck forward. Now the worst case scenario is that you have to unbolt the female part of the hitch from the trailer and replace it and the receiver assembly.
It also might work if you just chock the trailer wheels and adjust the location of the truck relative to the trailer so that you can lift the lever.
Spray the top latch and inside the ball with wd40. It’ll break free once you lift the latch and jack it up.
Chock the trailer wheels, hold the trailer brake. Pull forward a couple inches. Set the parking brake. Release latch and insert pin. Put truck in neutral and release parking brake. Let truck roll back. Put truck in park. Raise trailer.
Pull the pin on the receiver and drive forward.
I see rust, might need cleaned and lubed. Worst case, pull the pin on the drawbar and drive forward.
Coupler latch is down. Needs to be up to release it.
Maybe rusted, maybe off center. If you can’t get it, remove hitch pin from vehicle and drive forward.
Did you roll back toward the trailer when you parked?
It can bind the ball against the latch when that happens.
So raise the trailer jack so trailer is on ball, pull forward and set parking brake so tow vehicle doesn’t roll backwards, flip latch, drop the trailer jack.
You can chock the trailer wheels so it doesn’t want to move when you pull forward.
Source: Help! Can’t detach


