I am not an eternabond fan, but I think it is perfect for this. Trim the loose pieces off, clean well with rubbing alcohol and place 4 inch eternabond tape over the seam and extend down the side about r inches.
This is the slide roof. The roof rubber is still in tact and water tight. Original install has it tucked under the aluminum, but also folded over and glued. Should I just use regular Dicor non-leveling? Or is there something else I would use here?
Here are some more pictures….
I would just use some 4” eternabond and dicor the seams the eternabond will take years and years before it needs replaced and just touch up the dicor annually. By then you may be done with the rig or be at the point where you can or want to replace it or if you sell it then It would be a negotiating point.
Eternabond
I’d wager rubber roof solution. If you half-ass it your only going to be doing it again at the worst possible time.
Pretty much putting any sealant on is just going to be a temporary band aid, the membrane is shrinking and will only continue, the proper way to fix is to replace the membrane.


