I want to replace my factory stabilizers (low quality and some even retract with pressure). Is there a reason to install them on an angle like they are (and not parallel with or perpendicular to the frame)? Angled seems to minimize contact, but maybe there’s a reason I’m not aware of. I also don’t want to assume how the factory did it was the best.
As long as you can reach them to use them and all the fasteners are in the frame. I can see in the picture that the side facing us is held on by one bolt. I typically like more than that attached. I use self tapping screws so I don’t have to drill.
Parallel to the frame would make them harder to use. Perpendicular is ideal. Possibly at an angle so the pre drilled holes hit the outer flange of the I-beam instead of the main middle part? Looks like there are enough holes that you wouldn’t need to angle them though.
Source: Reason to angle stabilizers?


