Maintenance my Micro Mini. I was going to use an APC to clean the slides, rinse well and lubricate them.
I know there’s a special RV slide lubricant but I have this WD-40 Specialist Dry Lube and wanted to make sure it’s safe for RV slides.
To the “NEVER USE WD40 ON SLIDES!!” guys: it’s not normal WD40
PTFE is Teflon. For this spray it is in a powder form that gets applied with the propellant and carrier solvent that evaporates. The result is a very thin film of Teflon-like material.
This provides a very low friction lubrication. However, the durability of this lube is brief. You’ll need to reapply it frequently.
Courteously, your lubrication engineer
Ok, cool. That’s what I figured. Thanks guys
I’d use it. Anything that’s not wet/sticky/tacky should be good. I use Boeshield T-9, because I had it for my bike chains.
Pictures look like you have Schwintek slides, which recommend using CRC Power Lube. It also has PTFE like what you show, but is likely a much higher quality lubricant. Also importantly do you know where you’re spraying this stuff? It sounds like you don’t based on your comment about “rinsing”. DO NOT spray the tracks. The lube is for the motor shafts and bearings.
Read the label & description carefully, but the PTFE sounds right.
I have not tried it yet, but a local RV repair place sells Zep 45 Dual Force, recommends it for slides.
That should work fine….you want dry lube so that dust and dirt doesn’t stick.
Source: Slide Lubricant


