The water started sputtering even though the tank was full. So I thought well, we made it long enough on the original pump. Decided to pull it apart but these parts look fine. Should I wash them off and put them back in there? Or should I buy new ones? Or is this not the problem?
Ours has been sputtering lately. So much so that we thought we had a leak, or we were getting air in the line somehow. On ours there was a little filter under a clear cap in line right before the pump. That filter was filled with deposits. We cleaned the filter. The sputtering stopped but the pump would occasionally not build pressure. Then The pump was taken apart and cleaned also. It was not very dirty either, but did have a fine layer of scunge on the flappers. We’ve put it all back together and so far so good, but it’s only been a few hours since we cleaned them. Hopefully our sputters are fixed.
That sputtering could be from the check valve on the incoming water connector to the rig. If it isn’t closed all the way, the pump will suck air from the outside. Go check your exterior water connector, push in on the plunger of the check valve, and make sure it’s seating closed.


