Scrape of anything loose. Give it a rough sand. Rattle can something for metal and outdoor
I was pretty much permanently located. I built 2X steps that stacked up.
I’d (1) power wash them (2) wire brush and Ospho then (3) paint. The grip tape is a good idea.
Grease up the joints,use a wire brush, either hand held or drill attachment. Wash, air dry and rub it with denatured alcohol. Primer 1st then black paint. Anti slip tape will be needed as mentioned earlier. Be sure to use plastic and tape to cover everything not needing black paint (overspray). An easy day project.
Clean and use rustoleum truck bed liner rattle can paint
Wire brush > sandpaper > ospho > primer > 2-3 coats of rust oleum or similar spray paint


