This is the power outlet intended for a washer/dryer. I want to repurpose is to power my StarLink. But the actual sockets are capped. ie no actual holes.
Do I need to replace this with a proper outlet, or can I punch out the sockets?
Those are RV specific receptacles. They are total garbage. Do yourself a favor and replace it with a 4” square box, GFI receptacle and a raised GFI cover
Pull the cover off and if an outlet is under then plug something in to see if it works then put a new faceplate on
Could just be a faceplate to cover the wires. If that’s the case, go buy an outlet and wire it up!
So I just took it off the wall to look at it and opened it up. It has the wiring connected to terminals all ready to go, but just has those plastic covers over the actual sockets holes….
I highly recommend converting your Starlink to run off 12v.
Looks like you need to remove the cover plate and install an outlet. Be safe! Watch some videos and buy a voltage sensor that lights up when there is current. Don’t trust a label on a breaker to tell you it’s off or on. Also find out if they installed a breaker for this circuit.
It’s probably up in the cabinet above the stove or around where your microwave goes, so it’s should be good


