So I have a 2015 Yukon Denali we pull out little keystone bullet 243bhswe with (not actually the one in the pic but just like it, I just grabbed this off the net) the receiver is hidden behind a panel when not towing, and it makes for a higher placement compared to a standard truck which is fine I have set up my equilizer 4point perfect for it (many CAT scale trips to fine tune it). But I don't have a great spot to clip the emergency brake cable, on my truck the tag is right near the hitch, and I put an eye screw in one of the tag screws to connect to , but the tag is way higher on here. I have always been told not to connect to chains or the receiver hitch as if the hitch failed you'd want the emergency cable to be connected to a different point. Any ideas you guys have are appreciated.
Connect it to the safety chain holes like everyone else does. It’s not actually intended for if your whole hitch falls off the vehicle as that’s not likely. It’s designed for if the ball / trailer or the receiver / bar connection fails. The trailer falls onto the chains and the brakes then activate so you can now stop to fix the problem and trailer doesn’t come crashing through your vehicle. If the whole mess separates, that trailer is taking a wild ride to destruction regardless of if the brakes are applied.
I wouldn’t trust a license plate screw to activate it. Those screws are only held in by plastic anchors.
Right or wrong, I attach it to the receiver hitch when there’s no other options. A factory hitch in good condition is very unlikely to break. It’s essentially a part of the frame. I have less faith in aftermarket hitches or rusty hitches.
If you wanted, you could probably snake a small gauge cable between the receiver and the plastic bumper, and loop the cable around a frame rail.
You may have to get a longer cable but you should be able to snake it around the bumper attachment tube or look below the trim and see if there is a place in the frame you can clip to.
I had a GMC suv that was set up similar a few years ago and I grabbed an extra length of cable and clip and mounted it to the frame so I didn’t have to crawl around every hookup.
Source: Emergency brake pin connector


