Condenser drain holes are blocked. Go up on the roof and see if water is coming out of the AC unit. It should come out both sides from the condensation. If not it is filling up and eventually coming into the trailer.
If that is the case, search YouTube for videos how to clean out the condensation drain holes for the type of AC you have.
This has happened to me 3 times over the years and always the same issue.
Good luck!
A few things here.
A) Manual control ceiling assembly. It has no freeze sensor so it is unable to stop itself from freezing up.
B) Possible clogged evaporator coil. Look inside the air inlet and check. A lack of air flow will cause freezing.
C) Likely clogged drain pan. It is a Coleman and you will probably need to access from the top for best results.
D) Thermostat set to full cold. This does nothing to affect the outgoing temperature. It will always blow 20-25F below the incoming air. The lowest cold setting is 55F. Find the comfortable zone, about 2/3, and leave it there. Gives the compressor a chance to go off for a hit before having to kick back on.
Looking at it, id say your due for a cleaning. Inside and outside. Don’t be afraid to take the cover off once on roof.
Foam mounting gasket needs replacing.
Try cleaning the filters (inside the rv). Looks like they pop out.
If it’s leaking and not raining could be the filters are dirty or the drain is clogged and the condensation isn’t making it out. Depending on how cold you are trying to run it and how humid it is could be sweating.
Evaporation, results in humidity in the air, condensation is that humidity cooling, precipitation is when it’s falling down. This the water cycle, and it happens all around.
But jokes aside, air conditioners cool the humidity causing it to build up and drip. Normally there’s a place for it to drip out. But things like ground bees like to build their nests in small holes and plug them up on campers.
See if you can find a small tube/drain somewhere on you camper. Ours was obvious, but it was an early 2000s model camper.
We’d have to send a stiff wire with a small brush up ours.


