I think it’s coming from these connections what’s the best way to repair? Could it be the welds? What is that almost caulking type stuff?
Previous owner told me this was fixed. It’s clearly been a problem for a while.
That looks like an aluminum tank version. They last forever. It most likely the fitting vibrated loose and the pipe dope dried up. Pipe dope. I’ve switched over to Kevlar pipe dope vice the old Teflon. Kevlar dope comes in a blue labeled container and available at HD.
Turn off water, drain tank outside @ the pressure relief or if you have a wrench- the drain plug.
Remove fittings and clean and redope. If they have the cone washers, replace them and put a little silicone paste on the cones. No Teflon tape on anywhere. Hand tighten or at most 1/4 turn with channel locks after hand tight.
It “could” be the connection to the pex. If so, brass fittings are an upgrade. Amazon has them cheap. You’ll need a pex clamp tool and pex clamps also to replace the 90 degree fitting.
How old is this and what is the model number? If this is 10 years old probably buy a new one is my advice, but if its new, then you can redo the connections. Maybe the plumbers putty they used is not hot water rated, dunno on the quality of that glue. You are lucky you have caulk. Half my trailer from Forest River is un-caulked and i have had to caulk and caulk and caulk and its a 2020. I will be doing that this weekend again.
Source: My hot water tank is leaking.


