Step 1: Take the packaging off of the hammer
Step 2: Call a pro because that level of damage with moisture is not something that you want to get wrong.
It’s not a bad repair, but very time consuming. “Professionals” are hit and miss, either they will do it right, or slap lipstick on a pig and charge you like they did it right.
You’ll be ok, you are just in panic mode. Strip out all of the rot, vacuum it up and cut the wood back to studs (metal frame) so that it can carry your load. Once you’ve done that, it will be a matter of making sure the styrofoam is still OK – if it isn’t, replace it or patch it with the canned stuff. Cut a piece of PLYWOOD to go back in. Walk on it for feel. If you can’t screw it down, use PL adhesive and bond it where you can. From that point on, you’ll do things just out of the learning process, such as checking the base of that wall for stability issues, etc. You’ll do fine. If you do make a mistake, it won’t be anything terrible, possibly just cosmetic.
Sorry OP that rot looks bad. My 2019 Keystone Passport had issues with soft spots from moisture getting in from some where. I’m not a full timer but for the repair the manufacturer literally lifted the entire shell off our 38ft camper to remove the entire floor and replace it. Which is about an 8 week process they said.(it’s been gone for 3 months yet) If this is localized to just one spot the repair may not be THAT drastic but you may be in having to remove walls and fixtures territory to get at the floor. You may be better off finding an rv repair shop and seeing what they say.
That’s a tough fix. We had a leaking compartment door go unnoticed for a while in our front pass through storage. I replaced probably a 2′ x 4′ section of that floor.
Fixed the leaking door; removed all the rot/damage; aired/dried it out; treated for mold; remade the floor (luan + foamboard + luan) sammich; resealed the underneath of trailer.
It was not fun, and I had pretty decent access from being in the pass through. I think I’d seriously consider pro repair on that level of damage somewhere inside the trailer where you’ll be walking/standing.
A throw rug will take care of that.
Honestly even if you don’t know what you’re doing you will still do a better job than most professionals out there because they mostly just want to rip you off while not fixing the problem or even making it worse.
Step 1: rip out the bad shit
Step 2: clean it up
Step 3: replace and install what was ripped out
Step 4: make it pretty again


