Having trouble finding info on a google search, so far we’ve cleaned it and checked the regulator but no luck. This started to happen a couple months ago but now does it every time. It’ll heat up as usual and be fine for 15-20 minutes but then starts sputtering. Sometimes it will balance back out and be normal flow again after 5-10min of sputtering. Turning it off and reigniting doesn’t stop the pulsing flame. Could it be a temp gauge thing?
Is your propane tank overfilled? You can check using the little flathead screwdriver valve that should be on the tank stem. If liquid comes out, that’s bad. Should only be gas coming out
Possibly bad regulator at propane tank.
In an rv water heater that looks and works similarly it is usually a regulator or right by the pilot light there is a probe and that senses if the pilot is on. When the pilot light is on it keeps the gas valve open. If it’s faulty it will sputter on and off or not at all.
Well, as a special effects guy, I’m going to throw some industrial problems that come up on set: our stuff starts doing that when the propane becomes superchilled. That can happen by simply drawing liquid too fast or for too long in cold temps. This causes the pressure to drop, and the propane gas to stop flowing (in some cases liquid propane will flow instead).
I’ve no idea where you are, but if you are in the cold, throw the tank in some hot water for a few hours (no, it won’t vent), to bring the tank back up to the expected pressure. You are looking for a room temperature tank.
If all that checks out, well, my next thought is not so good – propane takes a very specific oxygen ratio to keep burning. If you’ve spray foamed it inside, or otherwise sealed it up, get a CO detector to make sure you have enough oxygen in that cabin. After 15 minutes of use, if your C0 isn’t venting, you might be hitting that ratio limit. My guess however, is that you have a kinked line.
The mercaptan added to Propane can build up and clog the valve or orifice. This often manifests as sputtering. Doesn’t take much.
Your selected temp has been reached. It’s just maintaining the set temperature. Perfectly normal. Perfectly fine. I would use a standalone thermometer in the oven to keep an eye on “actual” temp. Your control knob may say 350*, but experience says that may not be terribly accurate all the time.
Source: Oven propane starts sputtering about 15 min into cooking. Any ideas?


