dranyab1:

This can happen due to a few different reasons, here are a few in no specific order..

  1. If there was corrosion on the connector it could cause arcing which elevated the temp of the prongs.
  2. A loosely fitted plug can cause arcing and overheat prongs.
  3. To much current (exceeding 50 amp) exceeding current carrying capacity of plug overheating plug.
  4. Breakage of some of the copper strands from the prongs inside plug reducing the current carrying capacity overheating, this can happen from wear and tear or a factory defect plug.
  5. A faulty socket overheating can sometimes transfer heat to the plug (for same reasons above) meting it yet the socket appears normal because it was constructed with high temp plastics but your plug is not.
  6. An abnormally high current draw and coincidental Circuit Breaker failure.
  7. Excessive moisture.

SuperbPanic:

Electricity.. definitely electricity ⚡️

Kindly-Cap-6636:

That has all the hallmarks of a faulty connection. I would first suspect dirty or corroded prongs.

unknowndatabase:

Loose or corroded connectors is what did this. Wherever the melting took place is where the failure occurred. Your WatchDog is probably okay. Go to Lowes and get a new 50A female end and replace that one. Probably will be good to go.

aneurism75:

it faithfully did it’s job

Rmayer77301:

On your next one, put a fan of dielectric grease on it before use. Good on your plug into you tow vehicle, too.

Super-Disk7158:

Loose connection

Source: watch dog melted

How to Winterize Your RV eBook

FREE eBook...
'How to Winterize Your RV'

Your Guide for RV Winter Living & Storage.

Valuable Tips & Info help you prepare for cold weather. Includes winterization instructions for full-time or part-time winter RV living.

It's FREE and there's no obligation...
Download your copy today.

Thank You! You will be redirected to the eBook download page shortly... After you've had a read through, please let us know what you think about the 'How to Winterize Your RV' eBook.