It’s entirely due to the lift on your truck…
New trucks are too tall for fifth wheels already before you mods. I’ve seen people move the trailer axles from above to below the leaf springs to gain a couple inches. No idea how durable that is. Also have heard of adding square tube stock below the I beam and then remounting the suspension to that. KYD did it on their airstream.
Hopefully someone else that knows more can chime in. Good luck.
Installed my b&w patriot slider today. Went and hooked up my trailer. As you can tell it’s very nose high. Hitch was set to the middle position which is 18”. I didn’t bring tools with me to make any adjustments as I was in a rush. I just dropped the hitch to 17” which is the lowest it will go. There is also one more hole to go up on the pin box so a total of 2” of adjustment between the hitch and pin box. Think it’ll be enough? I also appear to have about 4” of clearance to the bed rails I’d assume it will increase as the trailer gets more level? What’s the minimum clearance I should have? Also what size nuts and bolts for the pin box? I don’t want to drag a toolbox worth of tools with me.
Does your truck have a lift kit and taller than factory wheels and tires?
I wouldn’t jack the trailer up you’ll just be raising center of gravity making it more top heavy and if you close the gap between the bed it will rub at some point as roads never stay level I towed mine nose high for many years you just have to unhook for each night stays but mine pulled fine good luck
Just put some Twankie Deuces on the trailer, you’ll be fine.
With a lifted truck you have to flip trailer axles.
Source: Nose high help. Info in comments


