Tank sensors are notoriously bad. Once something gets on them they frequently read incorrectly. Usually happens more often with the black tank but my gray tank will show that it is 1/3 full sometimes despite being open and connected to a sewer line.
I just dumped my tanks for the first time as well and here is a couple things I learned.
- the angle of your rv greatly affects how much you can dump and how the sensors read. If it’s tilted too far away from the dump, you won’t get it all. Also if where it’s parked is tilted too much it’ll show you either fuller or emptier than it is. As little as a degree off level can affect your readings.
- when you dump, you gotta do a tank flush. I used my in tank flush and it did practically nothing. We still had a large amount of waste that didn’t dump properly. I’m trying one of those tank flushes with the gate on it that you attach to the end. I’ve heard good things about those.
Lastly there could be waste on the probes showing its still a 1/3 full. That’s always a possibility.
I found that we didn’t have enough liquid to solid waste. Our tp use is a bit high and we weren’t flushing for 5 seconds after it went down, so our liquid exited but our solids did not.
Also awesome rig!
Tank sensors, even on new rigs are as reliable as a chocolate fireguard
You know what they say, black tanks are like politicians. They lie because they’re all full of sh*t ????
welcome to the struggle, the struggle is real, and it doesn’t matter what brand, how much you spend, the tank sensor technology is shit
Yeh I can explain this, and its NOT pretty. So we had a 17ft Casita and the drain pipes were very short, maybe just a couple feet to the tank, and when you pulled the valve it just went “woosh” and straight out in 5 mins. So now we have tada, Forest River NOBO, 28ft long, looks just like your , size wise, and the tanks are in the middle, and they take about 15 mins to drain. The slant is NOT very sharp so its slowly runs out. I now fill them all the way up and pull the valve and leave the flush out running the whole time, and it takes a long time. There is nothing you can do if its like ours because the made each tank face each other and then tapped them in the middle, on the side, not on the edge so I cannot say jack up one side of the trailer and it would be faster because it will trap something in some side of the tank. Fill them up all the way, flush, fill them up again with fresh water, flush. Thats what I do.
Ok, I just figured something out you can do. Look at your tanks underneath, and whichever is the Black tank, figure out the best angle to dump the black tank only. So mine being in the middle tapped on the side means I would have to raise my tongue up to get the Black at the best angle for high speed dumping. Do not worry about the fresh or grey and any water in them doesn’t do any damage. Worry about doing the black thorough and fast. This is what I will do from now on. Glad you posted, because it got me thinking about the best angle. So you need to know which way the pipe connects to the black tank.
Tank sensors suck. Just the way it is.


