Do i need to undo the seal and re-glue something or is it ok? Also do I need to add another layer of calking?
That cracking is normal and its why the rubber roofs eventually fail. In otherwords, the 10 year life they give you means, this will start happening 3+ years in and it will eventually crack all the way through withing 10 years, so they give a 10 year warranty. You can mitigate this now, if its just on the edges by using EternaBond tape on the seams. There is tons of videos on applying it.
The roof sealer when new can lift the rubber up but it will lay back down once it’s dried back out. Happens all the time when putting new roofs on. The rubber glue is water based and the sealer isn’t and they interact. Your fine. Just keep your eye on it for a bit. If you eternibond tape it and it still leaks good luck getting that tape off to fix it…
I agree with what chipmunk said. Also, seal up any of those clearance/marker lights your camper may have, along the seams. Most people don’t know they are also a main culprit of water leaks. A dealer told me that and I caulk mine and never had an issue anymore.
Don’t ever layer the caulking. If it needs redone, remove the old caulking first and clean the area with a solvent so you are putting the new down directly to the termination bar and roofing material. Layering is inviting a bad seal and then water has a way to get in.
I got a roll of the 4” Eternabond tape. For the wider front seal I used the full width and went right over the sealant. For the rest of the perimeter where there was the factory trim at the edge, I cut the Eternabond in half lengthwise and used a 2” strip. I put the outside edge of the cut strips on the visible side so any wobbles in my cutting aren’t visible from below.
Cutting the strip in half saved a lot since the 4” roll isn’t 2x the cost of the 2” roll.
Wondering if I should scrape it off, inject some glue under the parts that are pulling up, then put new sealant down. I used the auto leveling dicor. But it didn’t layer as thickly as the oem stuff. So you can still see the screw heads and such. Or I can leave it alone… Or I can put some of that sealant tape down and call it good.
Source: Roof issue


