No_Scientist5765:

Try spraying the threads with penetrate oil and let it soak for a bit. Work the bolt back and forth to free it up. Might use a wire brush to clean the rust off the threads first. Don’t use to much force or you will break something. Once it’s free and moving keep the threads oiled with something like neverseize.

Also is the nut that’s located on the top of the plate a lock nut? Sometimes people put lock nuts in hard to reach places.

Hope this helps

Scar1203:

Penetrating oil overnight, hit it with a cheater bar if it’s still stuck, if you strip it use a grinder and replace it. Put blue loctite on it before you tighten it back up. It will both keep it from loosening and prevent rust.

ZarquonLoC:

The two bolts on either side of the channel must be loosened first. That will allow you to raise and lower. Definitely use some type of loosener/penetrating oil on all first. After adjustment, tighten both side bolts.

Away_Pea_337:

Spray with rust inhibitor and let that sit for 15, they try the bolts again

Source: 2003 Dutchman. The main slide out gets hung up at the top of the wall, I went underneath to adjust the bolts that do vertical alignment and couldn’t get either of them to turn. Videos I’ve seen show a lock nut that you have to loosen before you can adjust them but mine doesn’t have one. Help!

How to Winterize Your RV eBook

FREE eBook...
'How to Winterize Your RV'

Your Guide for RV Winter Living & Storage.

Valuable Tips & Info help you prepare for cold weather. Includes winterization instructions for full-time or part-time winter RV living.

It's FREE and there's no obligation...
Download your copy today.

Thank You! You will be redirected to the eBook download page shortly... After you've had a read through, please let us know what you think about the 'How to Winterize Your RV' eBook.